- 您现在的位置：买卖IC网 > Sheet目录478 > MMDF2P02HDR2G (ON Semiconductor)MOSFET P-CH DUAL 3.3A 20V 8SOIC
MMDF2P02HD
di/dt = 300 A/ m s
Standard Cell Density
t rr
High Cell Density
t a
t rr
t b
t, TIME
Figure 11. Reverse Recovery Time (t rr )
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous drain ? to ? source voltage and
drain current that a transistor can handle safely when it is
forward biased. Curves are based upon maximum peak
junction temperature and a case temperature (T C ) of 25 ° C.
Peak repetitive pulsed power limits are determined by using
the thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal Resistance ?
General Data and Its Use.”
Switching between the off ? state and the on ? state may
traverse any load line provided neither rated peak current
(I DM ) nor rated voltage (V DSS ) is exceeded, and that the
transition time (t r , t f ) does not exceed 10 m s. In addition the
total power averaged over a complete switching cycle must
not exceed (T J(MAX) ? T C )/(R q JC ).
A power MOSFET designated E ? FET can be safely used
in switching circuits with unclamped inductive loads. For
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and must be adjusted for operating
conditions differing from those specified. Although industry
practice is to rate in terms of energy, avalanche energy
capability is not a constant. The energy rating decreases
non ? linearly with an increase of peak current in avalanche
and peak junction temperature.
Although many E ? FETs can withstand the stress of
drain ? to ? source avalanche at currents up to rated pulsed
current (I DM ), the energy rating is specified at rated
continuous current (I D ), in accordance with industry
custom. The energy rating must be derated for temperature
as shown in the accompanying graph (Figure 13). Maximum
energy at currents below rated continuous I D can safely be
assumed to equal the values indicated.
100
10
1
V GS = 20 V
SINGLE PULSE
T C = 25 ° C
Mounted on 2 ″ sq. FR4 board (1 ″ sq. 2 oz. Cu 0.06 ″
thick single sided) with one die operating, 10s max.
100 m s
1 ms
10 ms
dc
350
300
250
200
I D = 6 A
150
0.1
R DS(on) LIMIT
THERMAL LIMIT
PACKAGE LIMIT
100
50
0.01
0.1
1
10
100
0
25
50
75
100
125
150
V DS , DRAIN-TO-SOURCE VOLTAGE (VOLTS)
Figure 12. Maximum Rated Forward Biased
Safe Operating Area
http://onsemi.com
6
T J , STARTING JUNCTION TEMPERATURE ( ° C)
Figure 13. Maximum Avalanche Energy versus
Starting Junction Temperature
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MMDF3N02HDR2G
MOSFET PWR P-CH 20V 3.8A 8-SOIC
MMDF3N04HDR2G
MOSFET N-CH DUAL 3.4A 40V 8SOIC
MMDFS6N303R2
MOSFET N-CH 30V 6A 8-SOIC
MMFT5P03HDT1
MOSFET P-CH 30V 3.7A SOT223
MMFT960T1
MOSFET N-CH 60V 300MA SOT223
MMG3002NT1
IC AMP RF GP 3600MHZ 5.2V SOT-89
MMG3006NT1
TRANS GPA 33DBM 16-QFN
MMG3007NT1
IC AMP RF GP 6000MHZ 5V SOT-89
相关代理商/技术参数
MMDF2P03HD
制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Power MOSFET 2 Amps, 30 Volts Pa??Channel SOa??8, Dual
MMDF2P03HDR2
制造商:ON Semiconductor 功能描述:
MMDF3200Z
制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:DUAL TMOS POWER MOSFET 11.5 AMPERES 20 VOLTS
MMDF3207
制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:DUAL TMOS POWER MOSFET 7.8 AMPERES 20 VOLTS
MMDF3C03HD
制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:COMPLEMENTARY DUAL TMOS POWER FET 30 VOLTS
MMDF3N02HD
制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Power MOSFET 3 Amps, 20 Volts N-Channel SO-, DuaL
MMDF3N02HDR2
功能描述:MOSFET 20V 3A N-Channel RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube
MMDF3N02HDR2G
功能描述:MOSFET NFET SO8D 20V 3.8A 90mOhm RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube